Freelander - Fitting Rear Door Pocket
| Part No. RAWR3815LPR - Cost £11.26 ex VAT | |
Rear Pocket |
|
| Screw Fittings needed 8 x BTR9905 (sold in packs of 5) - unknown cost. | |
| Open Rear Door Fully | |
| Undo bolt on latch end of door - and keep safe | |
| Undo bolt on hinge side of door - and keep safe | |
| Undo Four Philips screw underneath door - and keep safe | |
| Remove panelling gently and work from inner side. | |
| Closer inspection reveals 7 dimples, these are were the net fits into. | |
| Drill these out from the rear with a suitably sized drill bit. (I forget the size). | |
| Make sure front holes are neat. | |
| From front of panelling locate net lugs through drilled holes. | |
| Push lugs all the way through so that net fitting is flush with panelling | |
| Nuts thread themselves onto plastic lugs of net. |
|
| Put all 7 nuts on a few turns to start threading. | |
| Slowly tighten each nut working along all 7 progressively, do not over tighten as this will strip the tread from the lug. | |
| Drop the rear glass and lift the weather seal from the top of the rear door so that panelling can be located on black U clips, then press panelling to door frame. | |
| Re-seat weather seal carefully, and raise glass to make sure that it is fitted correctly. | |
| Refit bolt at latch side of door | |
| Refit bolt at hinge side of door | |
| All fitted. |
