Freelander - Fitting Fog Lamps (STC53080) RHD
Fitting Fog Lamps (STC53080) RHD.
Note: These pictures are intended as a guide, this is a complicated install and should only be performed if you feel competent enough.
| Undo drivers glovebox cover. | |
| Remove Fusebox cover. | |
| Slot switch holder into cubby hole above fusebox. | |
| Mark two holes. | |
| Drill the two marked holes with a 3.5mm drill bit and a centre hole with a 12mm drill bit. | |
| Modify the wiring loom as shown. | |
| Feed the wiring loom from the footwell through the 12mm hole just drilled. | |
| Secure connector as shown. | |
| Attach the wiring clip to the wires in the order described. | |
| Now push the grey socket into cavity C591 as indicated. | |
| Use three tie wraps to secure connector. | |
| Pull wire through front of switch holder. | |
| Attach switch to connector and secure switch holder with two screws. | |
| Attach the three blank switches to the switch holder. | |
| Fit switch fascia and secure with screw. | |
| Feed wiring loom over heater unit as shown. | |
| Attach wire with clips as shown. |
